Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sunil
micro switch is used with the level switch for the
measurment of derator level in power plant
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Questions on flow meters,few questions on HART protocol,
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
How we connect a instrument with ground, Give brief explanation with help of diagram?
Draw block digram for well head from well to shipping pump?
Emergency Shutdown Systems/ Plant Shutdown System.
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Why MUX JB's are using only Temperature Element in Fundation field bus?
How to find out the current of two motors having same power consumption but different RPM?
whatis range of marcury filled tempereture gague
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
how to calibrate steam control valve in steam turbine
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
