What is working principle of washing machine?
Answer Posted / naveenkumar r
Low foam detergents lower the surface tension of water and
allow the clothes to become wet. The hydrophobic part of the
detergent attaches itself to the dirt and the hydrophylic
part of the detergent attaches itself to the water.
A motor causes the drum to rotate in half revolutions,
causing the clothes to be tossed from side to side.
A thermostat heats the water to a temperature suitable for
the fabric and the degree of soiling, i.e., 40°C for normal
washing and 90°C for heavy soiled cotton.
The soiled water is drained out of the machine through the
perforated drum and empties into the waste pipe. The drum is
filled again with cold water and the clothes are rinsed
(usually two or three rinses). The machine is emptied and
begins to revolve at high speed, exerting centrifugal force
on the contents (the clothes are forced against the
perforated drum and water is squeezed out of them).
| Is This Answer Correct ? | 49 Yes | 16 No |
Post New Answer View All Answers
what could be the RMS value and average value of a 4 phase sine wave?
what is capacitor voltage transformer?? how it is different from potential transformer?
What do you mean by reach and reach the point of the relay?
What is principle of Floroscent tube 36watt.
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
what are the 4 rules to start the motor?
what is the difference between neutral and earth
what is transistors comprised of?
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
How to select the proper VSD to operate high inertial load
what is the effect of higher value of GD???
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
Which motor connection is preferable star-delta or delta-star?
what is the chiller and working principal