Answer Posted / subhankar karmakar
by the drawing of the slab the reinforcement is placed
within a certain spacing calculated in design.the
reinforcement bar is placed in a bar one side crank and one
side straight alternative.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
What are the uses of alloys in daily life and how are alloys made?
What is construction mitigation management?
What is the outturn of Ceiling plastering
What is difference between combin footing & rapt footing
what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete
how can we construct building without foundation providing only grade beam at ground level
What in your past experience or education prepares you for the position for which you are applying
What does a construction cost covers and what does not?
What is the l/d ratio of cantilever beam?
What is the per cu. mt. price of ready mix in Gujarat region.?
How do you calculate the power of centrifugal pump?
What is meaning of Canceled/Flat Beam. What is difference between them? Both type of beam can bear same load if size (width)of the flat beam is increases and depth is same as slab thickness? Kindly suggest to me.
What is the compressive strength of fly ash bricks?
for G+2 residential building how much quantity of required in foundations,sub & superstructures per sq ft area
"how can we find the approximate quantity of materials using in a building or total Expenditure in percentage for rough estimate after known the construction area(sqm)".please if you know something about that please post the answer.
