Here iam a question with SYNCHRONIZATION PANNEL related
issue,
as i want to design a SYNC.pannel board iam giving the 2
nos of 1MVA Generators to sync pannel , then what wil be
the out put of the sync pannel, whether it wil be one cable
coems from the sync panel or two cables..
as iam using two transformers to meet my load demand,
so pls clear me whether two cables comes from sync panel to
connect to transformers or only one cable
Answer Posted / k.prakashchandra
One cable from synch panel and use a selector switch for each tr
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
What is knee point voltage?
What are the classifications of heating element?
how we design a pannel to start 10HP motor with the help of star delta starter?
Comment on the working principle of operation of a single-phase transformer.
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What will happen if the d.c. Machine is operated below rated speed?
What is the feedback in the control system?
3phase cable calculation formula by motor load
What is grid collapse? what is the reason for it?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
Explain about Leakage Test.
What is a differential amplifier?