Interested to Buy Any Domain ? << Click Here >> for more details...
what should be the attitude while answering an interviewer?
- 2 Answers
- 5452 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh sobhani
while answering to interviewer attitude shal be down to
earth and smiling.
make interviewer comfortable with you reply. and please
with smiling face.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
TECHNICAL/ARTITUDE
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
this site is owned by an nonsense
How earthing can be checked????
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
Which topics are covered in Process Control?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
How to calibrate H2s Dectector
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Full form of KKS when use DCS.
How to calibrate level transmitter with use of HART?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
the output of the common trasmitter protocol in qatar gas are the following
what is difference between HOT permit and cold permit
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
