Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shariff
The number cables connected to each individual phases is
called No.of Run for power cable. e.g if two cables are
connected to each phase then its called double run..
| Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
What kinds of decision are made about CT from it's Knee point(voltage & current)?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is the Nyquist criterion regarding control systems?
Why power genaration in India is at 50HZ while America its 60HZ
what is the meaning of 5% droop or 7% droop in AVR?
What is resolution of a measurement?
what are the reasons of CT circuit faulty in busbar protection scheme?
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
Why neutral point is consider as zero potential?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
