why transmition and distribution and genaration of voltage
in multible of 11 means 220v,440v,11kv,22kv,,,...so on
Answer Posted / shariff
It is the standrad maintained by the utilities and there is
no technical reason for that... It can be transmitted or
distributed to any vg levels with use of the transformers
of that rating.. but due to huge investment and already the
system is standradised so the same were maintained.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
What is lifting power for 1 wb/m2 and 1 A magnet?
DG SET BLOCK DIGRAM
Define peak time.
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
What is meant by Low Resistance Cable and High Resistance Cable.
What is meant by harmonic distortion?
xpression 'document.FrmQF.myemail' [
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
how was your last weekend.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?