Interested to Buy Any Domain ? << Click Here >> for more details...
single phase can run in PVC conduit. Three phase can also
run in one PVC conduit. But two phase cannot run in one PVC
conduit. WHY? reply plz....awaiting your answer.
- 8 Answers
- 17733 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / bhatt
In PVC conduit, one can run single phase, two phase and
three phase but two phases is not allowed in metalic
conduits as two phases can not cancel out magnetic field
and metalic conduit can induce voltage which can lead to
fatal accident.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
What does the term power factor shows?
What is the basic principle of welding process?
How to know the Max. current caring capacity of the cable by its size ?
How to determine alternating current frequency?
What is the maximum percentage voltage drop (vd%)for a motor control center
wat is d diffr btw shunt coil and trip coil in VCB?
State ohm’s law?
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
why output is out of phase in case of common emitter?
where lt & ht capacitor used
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
