Interested to Buy Any Domain ? << Click Here >> for more details...
For 1 KVA load how much KVARH capacitor can be used ?
- 3 Answers
- 11765 Views
- NLC, TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
KVAR not KVARH
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
Starting Time of LT & HT Motor
what is resver in electrical enginnering with answer
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Dear all i am kumaravel. now in chennai. my work is control and relay panel auto cad designing.up to 11kv to 400kv then question is i am improving my knowledge. i want some books name and auther are available for this C&R panel related. plese any one help me
how to calculate the distance relay faulty zone?pls explain?
Ratings of power transformer,Distribution transformer.
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
how to calculate insulation level of transformer?
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
Merits & Demarits of Oil circuit & Air circuit breakers ?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
