Interested to Buy Any Domain ? << Click Here >> for more details...
what will happened to give the dc supply to ac transformer?
- 3 Answers
- 6336 Views
- Sail, I also Faced
- E-Mail Answers
Answer Posted / tarun aggarwal ymca
If DC supply is fed to a transformer's primary, then inductive reactance X1 and magnetising reactance X0 becomes zero. The no load branch contain a parallel combination of R0 and X0. As X0 is zero so that the impedance of no load branch is zero. and current being the ratio of Supply Voltage and no load impedance is very high as it burn the primary winding.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How two nos. 130 kw D.C motor get synchronise using D.C drive.
how to increase or decrease speed in DC shunt motor by DC convertor
what is cascade speed control device?and how this device control the speed of motors?
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
List the power rating of any 5 important electrical appliances used in houses.
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
What is cut-off rate?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
do you have some of interview Questions in power and genrator section in general whith answers
one split ac how can told of this ac which Tr tell me us
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
Explain the method to keep noises low in a control system?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
How calculated single phase induction motor req. Capacitor?
What is the fault or needs to be done when frequency in ac drives is not changing?
