Interested to Buy Any Domain ? << Click Here >> for more details...
what is the purpose of checking IR and Megger values in
motor windings?
- 5 Answers
- 9959 Views
- I also Faced
- E-Mail Answers
Answer Posted / prasang
IR is tested to check the soundness of insulation resistance & freedom from earth leakage faults between phase to phase, phase to neutral, phase to earth and earth to neutral...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the distance between each insulator in 33kv transformer and how can it calculate
why the voltage and current in a long transmission line are called travelling wave?
DG Earth Value?
what is meant by twilight switches 7 where its applicable ?
What about electrical Units. discrive in detail
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
What is the Minimum winding resistance of motors ( small & big)? referance range
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What is meant by Low Resistance Cable and High Resistance Cable.
How many size of cable required for a 300m long and 30kw inductive lode
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How much ph is maintained of water resistance starter for slipring induction motor ?
What are dcs and plc?
