I am a electronics and instrumentation fresher trying for a
job in IT sector. what do need to prepare for the interview?
Answer Posted / guest
learn c ,c++ ,and java thats enough
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How is PH sensor works ?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What is Cavitation in a control valve?
Explain the difference between mmwc and mmwg?
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
What is the difference between working pressure and calibration pressure of a control valve
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
Explain PID, ON/OFF, Controls
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
draw the block diagram of a level transmitter ?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Explain why plc require in analog input 4-20amp & 0-10 volt?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
full process of gas turbin?