Interested to Buy Any Domain ? << Click Here >> for more details...
In RTU Panel we are having several Analogue & Digital
Inputs /Outputs. We are recently facing some problems over
Analog inputs , which are not updating properly (But
Digital Input are updating normally) Can any one tell me
from where the problem is creating , we have checked PLC
CPU card, Analog Input card & we reconfigured ,But still
the issue is there.
Issue :
1. Sometimes Analog values are updating & sometimes not.
2. Analog values are not updating normally , showing some
wrong Values
3. Total dead (0 value)
Analog values are Level & flow measurement from the field
instruments.
(But in field the instruments are working normally &
Displaying the values normally in local display unit)
This problem we are facing in our Water Plant.
If any one experienced this same problem or having any
ideas related to our issue PLS send your valuable
Answers/Replies...
- 6 Answers
- 8889 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / guest
analog values are normally between the limits.... if we are
changing the inputs...depends on that the output is vary...but
it is there in between the limits
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the GK Value in Flowmeter?
Can anyone send most commonly asked interview question in Oil & Gas industry
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
field bus transmitter calibration procedure tell me
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
What is heating effect?
What is 3 selection available when configure the burnout protection for controller
why Fahrenheit unit of moistur analyzer transmitter
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
Any one can help me to identified, how can we interchange the device in FF
what is interlock system and why we use of this?
What is ultrasonic flowmeter?
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
Make Heater Process Logic.
explain key exchanges in all security modes WPA,WPA2,TLS?
