Interested to Buy Any Domain ? << Click Here >> for more details...
Can Superposition theorem be applied to AC Circuits?Can
Thevenin's Theorem be applied to AC Circuit too?
- 6 Answers
- 21360 Views
- HCL, NPCIL, Shivam, Vast, I also Faced
- E-Mail Answers
Answer Posted / anudeep singh
Any combination of sinusoidal AC sources and impedances with
two terminals can be replaced by a single voltage source e
and a single series impedance z. The value of e is the open
circuit voltage at the terminals, and the value of z is e
divided by the current with the terminals short circuited.
In this case, that impedance evaluation involves a
series-parallel combination.
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
Is there chopping current in resistive circuit
Safety of on line ups
how can i reduce sparking without stepdowning the voltage
List out the different frequency domain specifications?
operation of diesel generator
Can clean earth cable be considered as low current cable
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
What does a Bode plot tell you?
why should the primary of transformer be connected in delta in a heat run test?
Explain about 3 phase motor fault current calculation with examples?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
how freewheeling diode improves the powerfactor
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
