WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL?
INSTEAD OF 4-20mA.
Answer Posted / lalatendu keshari prusty
4-20ma signals will travel along distance without dropping signal value and the internal circuit distinguish between connection break & minimum value.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Please tell me details about Sox,Nox,SWAS analyser????
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What is the difference bitween control net scaner and device net scaner
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
What is the use of gauge?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
What is zero elevation and zero suppression?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
What is difference between ESD and PLC please Explain me clearly.
Is there any relation between Artificial Intelligence and Instrumentation?
Specify for Cables - Flame Retardant and Fire Resistant?