how to calculate interface capelary level transmetar lower
S.G.0.54 and uper S.G. 0.26 and h=490 mm
Answer Posted / ashish namdev, bina refineries
Your Que have some mistakes in SG Data
After removed mistakes you wll got
URV=264.6
LRV=127.4
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
for oil & gas industries which zone is normally preferred? why? give its example?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
What is the purpose of LO Overhead tank in turbines.
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
How to check vortex flow meter is in good condition while we do not having calibration setup?
wich is coming the first HAZOP OR SIL
Explain about the leakage class of the control valves
How earthing can be checked????
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Galvanizing.
There are many type of control cable like pair,core,tried, What are defination each one
what is IEC code in cables & how to selecting cables?