Interested to Buy Any Domain ? << Click Here >> for more details...
How we calculate the size of H.T cable for any transformer &
rating of busbar for any L.T. panel?
- 3 Answers
- 9057 Views
- I also Faced
- E-Mail Answers
Answer Posted / cameo_0102
to know the desired
rating of busbar
just multiply its
width & height(not
length),the result
will show the max
load,that it can
bear.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If one lamp connects between two phases it will glow or not?
please give me solution to rectify the emi(electromagnetic interference)
What is the function of electron gun used in crt?
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
how to control dc motor?
What is “pu” in electrical engineering?
what is the cause of voltage dipp or swell in the transmission lines?
how to find the Motor,s insulation Power?
what are the specifications we must look at to select a relay for any capacity motor?
how does the thyistor work in dc drive?
what is rating boiler
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
DG Earth Value?
