Which Programming software are use for Allen bradley PLC's?
Answer Posted / venkateswara aro
Rs logix 500 for midend plc(SLC)
Rs logix 5000 for high end plc
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
please send me last 5 year interview questions
whatis the commertial spec. of distribution boards ?
What will be result if we connect LT votage to the terminal of HT motor?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
What is the resistance of the field winding of a d.c. Shunt generator kept low?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
What is a single phase autotransformer?
List out the different frequency domain specifications?
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
what is the transformer rush current?
What is CVT and what is relation with wave trap?