Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the output of a temperature transmitter if
temperature is 120 degree celcius?
- 6 Answers
- 11719 Views
- KNPC, I also Faced
- E-Mail Answers
Answer Posted / sami9-
the above ans is crocet
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Programmable Logic control.
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
In turbine, what does term CDP, NI, NH, HSSOC, means
define feed forward control loop with example and drawing?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
give me all the details about the interview and which type of question being asked
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
what is metal of piston ring
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
What is the purpose of the analyzer in petrochemical plant?
What is Erosion in a control valve?
you are on site,the plant trips,you are approached by operations,what do you do?
