1. what type of winding of slip ring ac induction motor
rotor and why. 2. how the heating element use in two phase
(415 volt)and what rating of element, you prefered.
Answer Posted / k.prakashchandra
Regular 3 phase windings for both stator and rotor.I don't
think heating element is provided .A low voltage is applied
to windings with help of a transformer so that a current
equal to or less than full load current is circulated to
warm up the windings .The voltage and capacity of this tr
depends on the rating of the motor.As the stator is normally
delta wound, one coil gets the full voltage and other two
50% each.As you press the start button ,the transformer gets
disconnected or you can switch it off beforehand.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
While testing a ZCT what parameters have to check or measure?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
Sate maximum power transfer theorem?
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
1.what is meaning of curve into a mcb. 2.what is basic reason changing of curve
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
Please send 110 kv sb station full single line drawing(sld)
What is the maximum and minimum rating of UPS?
Refernce currents are to be generated using refernce cueernts how can this be done??
Why is the air gap between the pole pieces and the armature kept very small?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?