Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any thumb rule for cable selection for any current
rating ?
- 1 Answers
- 5539 Views
- I also Faced
- E-Mail Answers
Answer Posted / subhendu
Normally by thumb rule we can take, for Al cable it is 1.5 times(Amp) of its sq mm size, and in copper cable it is 2.5 times .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Can anyone explain me about the capacitor calculation
operation of protection relay watchdog contact?
What is open loop and control loop systems?
What will happend if given Vfd out put to step up transformer
diameter of cable and core is doubled then the value of capacitance is
how to check three phase motor torque value?
Define gain margin?
can i use 2000/5A Clamp meter to measure HT cable
what is the principle of operation of CFL ??
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
What is the most important precaution in any experiment with d.c. Shunt motor?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
How to calculate cable rating for 3 phase supply?
