Answer Posted / tejas mehata
the branch engg that deals with the technology especially
for design the circuit and operating equipment from the
control room in the corporate world.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why chock were used in old tubelights but are not newest tubelights?
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
Vaccum circuit breaker
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
What are safety device in vcb and acb?
Why do we perform an open-circuit test and short-circuit test on the transformer?
How many types of circuit loads are there in a common electrical circuit?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
What is reverse power relay?
What are hrc fuses and where it is used?
what is meant by motor startup supervision & motor load jam protection ?
What happens if we run alternator on under frequency?
mention hazard experienced during installation