Interested to Buy Any Domain ? << Click Here >> for more details...
To attain a powerfactor more than .95, how much kvr should
we use for 100 HP of current
- 4 Answers
- 10218 Views
- Bhel, Scooters India, I also Faced
- E-Mail Answers
Answer Posted / r. thirumoorthy
I DON'T KNOW EXACTLY, ITS MAY BE CORRECT.
POWER FACTOR=KW/KVAR;
IN THIS CASE WE KNOW KW VALUE INDIRECTLY 1 HP=746 WATTS
SO 100 HP=74600 WATTS
AND POWER FACTOR=0.95
THEREFORE REQUIRED KVAR=74600/0.95=78526.315
IF IT IS WRONG SEND ME CORRECT ANSWER.............
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is the universal motor?
Do u know any one? how to find out in motor rated amps? formula?
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
does buccholz in a transformer use batteries
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?
What is step signal?
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
how to calculate the settings for shaft ct protn in hydro generators
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
