Interested to Buy Any Domain ? << Click Here >> for more details...
Our Alternator nameplate specifies a power factor of 0.8.
When the Alternator is on light load, the bus bar voltage
rises to 11240 volts, whereas the standard value is 10500 volts.
Is it ok to increase the power factor to 0.85 or 0.9. I am
afraid because the power factor on the name plate is only 0.8 ?
- 3 Answers
- 6472 Views
- Escube, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It is not advisable to run the gen at a pf lower than 0.8.
You can surely run at a better pf.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
How to select the proper VSD to operate high inertial load
how was your last weekend.
Is there any abbrevation for STUB in Stub bus protection
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
Why Neutral Isolation is required?
what is mean by restructuring power system?
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
State and define ohm’s law?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
Explain how you intend to work under pressure to meet up with deadline target?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
how to get bearing & winding temperature of an induction motor?
