Interested to Buy Any Domain ? << Click Here >> for more details...
hay friends, i am in trouble to understand PID controller.
several times i have study but it is not clear to me have
you a simple way to understand.
- 1 Answers
- 4144 Views
- I also Faced
- E-Mail Answers
Answer Posted / yashwant
SEE THE SIMPLEST WAY WILL BE DEPEND ON YOUR REQUIREMENT OF
PROCESS, WHETHER YOU WANT SLOW OR FAST RESPONSE AND ACCURACY
YOU WISH. P VALUE FASTEN AND SLOW DOWN PROCESS, IF YOU REDUCE
VALUE OF P LESS THAN 1 PROCESS WILL BE ACTING VERY SLOW AND
ACCURACY ALSO WILL BE GOOD, AND IF IT IS MORE THAN 1 SYSTEM
ACTS SOME WHAT FAST AND FORWARD O/P IS EXPECTED.
I VALUE DECIDE THE SPAN AND SPEED WHILE REACHING SP AND AWAY
FROM SP. D IS USED FOR VERY FAST RESPONSE IE ON OR OFF VERY
FAST ACTION IT IS USED VERY RARELY AS PER PROCESS REQUIREMENT
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
what is basic difference between motion balance and force balance in pneumatic instrument?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
Why plc require in analog input 4-20amp & 0-10 volt?
why we take %i0.0 as input for twido plc
what is actual drum level and compensated drum level?
what is the calibration procedure for magnetic flow meter @ onsite
What are the application of bernoulli’s theorem?
what is droop in governer ,type of droop ,how it work
