Interested to Buy Any Domain ? << Click Here >> for more details...
Our Alternator nameplate specifies a power factor of 0.8.
When the Alternator is on light load, the bus bar voltage
rises to 11240 volts, whereas the standard value is 10500 volts.
Is it ok to increase the power factor to 0.85 or 0.9. I am
afraid because the power factor on the name plate is only 0.8 ?
- 3 Answers
- 6469 Views
- Escube, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You can increase pf safely. 0.8 pf is employed for design
purpose only to fix the the maximum current.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is transistors comprised of?
send me any model test paper of clerical post of state bank of india.......
what is model question rrb junior engineer electrical gr.II
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
Post possible questions for Power Factor Panel FAT / SAT
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
What are m circles?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
When we need up only in o/p 440v, so why we use directly in 11kva in input?
for 750 kw LT load what will be the ht kva
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
What is the difference between alternator and generator?
What is the lockout relay
What are the causes for the failures of sandwich type (Al) busducts?
what is the chiller and working principal
