Interested to Buy Any Domain ? << Click Here >> for more details...
Why the tapping connections are taking above for gas
service and below for liquid service?
- 4 Answers
- 8528 Views
- I also Faced
- E-Mail Answers
Answer Posted / imran mansuri
For gas and vapor flows, it is important that
no stray liquid droplets collect in the impulse lines
leading to the transmitter, incase vertical liquid
column begin to collect in those lines and generate an
error-producing pressure For liquid flows, it is
important that no gas bubbles collect in the impulse lines,
or else those bubbles may displace liquid
from the lines and thereby cause unequal vertical liquid
columns, which would (again) generate an
error-producing differential pressure.
In order to let gravity do the work of preventing these
problems, we must locate the transmitter
above the pipe for gas flow applications and below the pipe
for liquid flow applications
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
where proximity sensor installed on tank in loading arm application
can you send remote seal interface level transmitter calculation steps for oil water saperator.
give me all the details about the interview and which type of question being asked
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
what are the different types of Protocols? & their applications.
how to calibrate steam control valve in steam turbine
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
How to Calibrate Flammable gas detector in field
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
what is scale factor of proximitor & unit of the vibration.
What is the difference between uv and ir scanners? and what is the workig principle of both
In which principles tx ,pressure gauge,Temp gauge,control valve works?
What is 3 selection available when configure the burnout protection for controller
