Answer Posted / manoop m

this is because of the position of kicker in the
transmissdion system The general power transmission system
for bike is engine- clutch- gear-wheels. In the first
case the kicker of bike is placed in between engine and
clutch. When we hold the clutch, the contact between clutch
palte and gear system breaks threrefore the power from the
kicker directly obtained in the engine. in the latter case
the kicker is placed in between wheels and gear system .
when we hold the clutch the contact between gear system and
clutch breaks therefor no power is transmitted to the
engine

what is the technology used in sap?

2235

---

hi,i am sekar.i am prepareing Assistant Motor Vehicle Inspector in TN.Transport ,if any one have previous year model pares or some questions,pls send me at gpsekar2007@gmail.com.

2020

---

Out of electric heater and heat pump, which is economical in operation ?

1114

---

Hi any one can help in preparing for BHEL ET exam in mechanical stream? I like to know the the question paper pattern fro the same. regards, Jose 9841327666 josevinoth@yahoo.com

2399

---

What happen when too much cylinder oil is injected in the working cylinder?

1913

---

What is a combination thrust and radial bearing?

1234

---

• How can you justify it?

2085

---

How much of MSW waste is to feed to produce 1MW ?

1546

---

We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

2665

---

How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?

1059

---

meaning of 125kva DG

2191

---

If any changes done in the process of production what that is called.

1900

---

How does a boat measure speed?

1170

---

what is the pattern of written test for the post of trainee mechanical engg.

2218

---

rrb junior engg mecf questine papers

2214

---