Answer Posted / k.prakashchandra
It depicts almost all characteristics
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
Why computer humming sound occurred in ht transmission line?
what is the purpose of bypass mode in energy lighting transformer?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
Do u know any one? how to find out in motor rated amps? formula?
IN dc capacitive reactance is??
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
what is meant by tranformer impedance?
How much of the total hydro power potential has been exploited so far in india?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
what are factors to be consider to design a HT & LT motor?
What is the ratio of Booster transformer?
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
How to check the cable fault / hv test of transformer cable.