Answer Posted / k.prakashchandra
Galvanized Steel ?
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Which motor connection is preferable star-delta or delta-star?
Can any body tell gulf interview question for experienced electrical engineer ?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
what is cogging and crawling
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
Why we are use dol starter up to 10 hp
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
What is the use for cable entry in control room?
What is DTR erection?
Transformer diagram mention each parts ?
What will be in Mahagenco Trade Test Exam? I want to know the same.
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
Difference between drift current and diffusion current?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?