Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abc
silicon controlled rectifier. it is used widely in in
electrical.it is used to controlthe power & by changing the
phase angle it controls the power.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the types of power in electrical power?
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
Is a d.c.compound motor is use as a booster? how?
which is the best institute for PLC,SCADA,DCS in hyderabad
State superposition theorem?
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
Give some example of fault limiting devices?
what is the maintaining Cf in UPS.
what is ground fault in ACB?
What information we need to prepare relay coordination chart
What is inrush current? how can calculateit? what is the affect of it?
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
