Interested to Buy Any Domain ? << Click Here >> for more details...
How to conduct the Hydro & Pnumatic test as per DIN & ASME
sTANDERS?
- 1 Answers
- 4170 Views
- I also Faced
- E-Mail Answers
Answer Posted / ankur sahu
first create a loop in which pressure all over is constant .
then make all vent open to remove all air inside the loop
and blind the end of the loop with required thickness. then
filled water and maintain pressure 1.5 times of the design
pressure.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Is it able to make FMEA for Pencil creation? If yes send the FMEA
What is the law of thermodynamics?
T union support factor
What are the causes if one cylinder in a diesel engine has a high temperature?
Which one has higher efficiency - Diesel Engine or Petrol Engine?
why screw pump are used insteed of centrifugal pump?
What ill be the shaft diameter with clearance having a bearing bore is 30mm?
Which technology is better for designing an STP system in a Commercial Mall. 1) SAFF (Submerged Aerobic Fixed Film) or 2) FAB (Fludized Aerobic Biological ) or 3) Some other.
Enumerate the parts of Main Switchboard
State the function of neck ring in centrifugal pump?
Which type of question u have asked to the fresher
Dear friends, i am a student of mechanical final year in rajasthan. If you have any type (Technical,interview, aptitude) of question paper related to BIRLA CEMENT LTD. than plz send me these paper at vinodsainikumar4@gmail.com thanks
what is the type filter in clean side in ge 9 fa gas turbine ?
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
How much calorific value of heat is needed to heat 00c of
