In a transformer ,when voltage decreases current increases.
but this is a violation of oms law.why?
- 15 Answers
- 20222 Views
- I also Faced
- E-Mail Answers
Answer Posted / lijo joseph
If you take primary or secondary circuit individually, ohm's law holds at all instants....voltage inversely proportional to current is taken considering both the circuits together,ie, its a relation connecting primary and secondary....as per law of conservation of energy,input power and output power must be the same....
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
There are different classes of protections in power plants.class a,b,c are clear..is there any class d and e r there..and elaborate class b protection.
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
Z transform is use when system is not a) converges b) diverges
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
hello if any one have papers vof hpcl or sail, plz send me
what is the ms flat constant for calculating earth mat design calculation?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
How the capacitance og capacitor volatage transformer is decided?
what is the concept of directional power?
Salient pole alternator is more stable, why?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
use of choke in APFC panels
