Answer Posted / balram yadav
inverse transducer coz inverse tranducer converts an electrical energy in some other form of energy
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
i need some objective type questions in instrumentation
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
Identification of control valve parts.
How to calibrate Field bus transmitter? procedure ?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
why Fahrenheit unit of moistur analyzer transmitter
Tell about your IFFCO plant visit.
Valve positioner and actuators in detail.
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What is force balance principle? State some of its’ advantages.
what is the procedure of O2 sensor(ABB) calibration?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?