which relay is used for both detection & correction?(there
is only one relay)
Answer Posted / k.prakashchandra
Such relay is possible in digital systems such as
telecommunication.I think it is 'frame relay'.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is electrical cable termination
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
What is the difference between acs 550 & acs 850
Why corona leads to production of Ozone and glow of the color VOILET?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
State kirchoff voltage law?
how to measure earth resistance of a substation
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
Why is remote backup preferred to local backup?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
33kv substation lay out details & line to line & line to earth measurements
how to define tell me about self
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
wheather the size of windings in motor and generator are the same