Interested to Buy Any Domain ? << Click Here >> for more details...
What is principle of ultrasonic level transmitter?
- 3 Answers
- 10612 Views
- I also Faced
- E-Mail Answers
Answer Posted / naabil al-eryani
The transmitter is designed to be mounted above a liquid
and uses ultrasonic pulses to continuously measure the
distance to the liquid surface.
The microprocessor-controlled electronics calculates
distance to the liquid level from the time delay between
the transmitting and receiving of signals.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
How is work 5/2 sov?
What is difference between differential pressure & delta pressure?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
What is difference between radial vibration and axial vibration explain in detail .
what is maxdna ?. explain about the software details.
In which principles tx ,pressure gauge,Temp gauge,control valve works?
wich is coming the first HAZOP OR SIL
what is function of sensor, and how is it work , explain with difination
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
