Interested to Buy Any Domain ? << Click Here >> for more details...
TRANSDUSER MOSTLY CONVERT WHICH ENERGY INTO ENERGY ?
- 6 Answers
- 8990 Views
- DVC, I also Faced
- E-Mail Answers
Answer Posted / amar9
transducer converts mechanical energy into electrical energy
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Why mmwc unit is used?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
What is the working principle of the magnetic meter?
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
What is mean by analytical instrumentation?
how to convert cubic metre per hour to newton cubic metre per hour
when a magnet is heated?
what deference between panel earth and systemearth
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
What is the procedure of calibration of Load cell?
NSV type probe stands for
full process of gas turbin?
List three types Level Gauges with their working principles
How ejector(or)evactor air pump is working in thermal power plant?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
