Interested to Buy Any Domain ? << Click Here >> for more details...
why to use 50hz only in tansmisson and as well as in
distribution why not60hz?
- 2 Answers
- 4310 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanju
bcoz all the equipments in India are designed according to 50hz frequency supply!
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
how the phase convertor changes the no. of phases
which VFD is better ( LT or HT)
what is effect of length of air gap on performance of dc motor and generator?
What are gain margin and phase margin?
Explain about p.t?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
Ratings of power transformer,Distribution transformer.
what is the difference between RMS & TRUE RMS VOLTAGE
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
what is parellel power factor correction?
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
what is buffer resistance starter.?.What is the working principle and where it is used..?
why electron produce magnetic field when it is in motion?
how does high earth to neutral voltage affect electronic equipment?
