tell 2 reasons for why only copper is used in domestic
wires& only alluminium in transmission lines ?
- 10 Answers
- 14787 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / santosh.s
alluminium low cost & ht line voltag high & amper low
domestic line voltag low & amper high.because copper
carrant capaciti good & copper flxibal for useing.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Draw the line diagram of diffretial relay connected to transformer?
my diploma certificate in my higher education college
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
Is there any standard guidelines/Criteria to design NGR/NGT.?
If not into production, how far did you follow the design and why did not you see it into production?
What is the formula of frequency ?
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
I am an American living in Vietnam and I have recently gotten a refrigerator from Japan and it is rated for 100 vac, but the power here is 220 so I bought a voltage stabilizer it has a 1 kva output rating. Can you please tell me what the amperage is? I'm confused and without a working fridge.
Why we use ups battery and dsdb battery in thermal power plant
Which material is used for the core of a transformer and why?
Explain the operation carried out in thermal power stations?
why we use single core 630mm2 cable for transformer secondary side
