Answer Posted / k.prakashchandra
No. Frequency is measured in Hz only.If you add number of
phases you get system of supply.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
At what speed 1 HP motor can run an electric car of weighing 400 kg?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
how to calculate the conductor size for certain KV transmission line and distribution line?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
What are the different types of hydro schemes?
How earthing of switchgear system to be done.
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
how does ELR works? explain
IN 1000kva transformer where the oil and winding temperature sensors is connected
In radial network the source is fed from 1 end both ends at central
What is acsr cable and where we use it?
What must be the minimum distance maintained between 2 Generators as per International standards?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?