in alternator permanent magnet generator
is also connected on the alternator
shaft,then y that PMG voltage is very low
as compared to alternator?
- 1 Answers
- 2664 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Voltage generated is also proportional to flux and number of
turns.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How much dc volt applied in cathodic protection system?
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
What is resonant frequency?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
What is the ratio of true power to apparent power in an ac circuit?
why need to be maintain power factor for industrial customer?
ROC converges if poles and zeros lie inside a. Origion b. Z=1
How can a equal potential zone be carried out in conductors?
in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
what is the transformer turn ratio formula and give some examples?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
What are your future plans for the company if permanently employed?
