Interested to Buy Any Domain ? << Click Here >> for more details...
On monitor it is written that current rating is 2.2 Amps.
Is it a monitor current drawing capacity or CPU & monitor.
If it is only monitor rating, what will be the rating of
only CPU and what will be the power consumption rating of
PC, Monitor & Scanner?
In net, I learnt that computer consumes only 200-300W while
running. With the current rating of 2.2 Amps, how it could
be 200-300Watts. Please explain?
- 3 Answers
- 5725 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
I think that it is written as 2.2 A max.The monitor has a
tube warming heater which automatically switches off as the
required temp is reached.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
what is static frequency converter?what is the function...of sfc...?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
what are the reasons of CT circuit faulty in busbar protection scheme?
Why is better to have a minimum ceiling voltage of 250% than 160%?
how we can calculate power factor in single phase & three phase ?thank u
how to convert lv line to hv line and viseversa, any losses will occur during this process
What are the transformer losses?
what is the use of sdf?
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
What is the unit of attenuation?
