Interested to Buy Any Domain ? << Click Here >> for more details...
What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
- 14 Answers
- 135532 Views
- Ensol, GNFC, Reliance, Siemens, I also Faced
- E-Mail Answers
Answer Posted / atta
An eddy-current probe works by passing an alternating
current through a coil of wire and measuring the coil’s
impedance(Resistance to flow of AC current). The coil is
supplied with a alternating current from the remote
eddy probe driver, which sets up an electro-magnetic field
between the tip and the observed surface.
When any electrically conductive material within this
electromagnetic field, ie. the target material, will have
eddy currents induced in it’s surface. These eddy currents
will vary produce there own magnetic field but in opposite
direction of probe field, and hence the impedance to
energising current, in proportion th the probe target
distance.
The sensing electronics in turn convert this impedance
change to a voltage, providing an electrical output
directly proportional to physical gap.
| Is This Answer Correct ? | 37 Yes | 4 No |
Post New Answer View All Answers
How is PH sensor works ?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
How to calibrate Toxic gas detector?
can any send me a forbes marshall dtron 316 manual
Why humidity limit is 30 to 55 % for raw material storage?
which type of zones used for boiler? & why ?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Definition of reverse and acting controllers:
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
List three types Level Gauges with their working principles
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
Draw a great bridge circuit.
What is three element drum level control system why its better than single element?
how to work MIL contol valve posistioner ?
Emergency Shutdown Systems/ Plant Shutdown System.
