Interested to Buy Any Domain ? << Click Here >> for more details...
in a refinery one motor is suddenly stoped. what
will do
how can i findout the problem explain step by step
- 2 Answers
- 4394 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradeep jangid
First of all we check for supply is proper than Starter
after this Check circuit is open or not than check some
fault(Mechenical or Electrical)occured in Motor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the formula to calculate a three phase alternator
What is the main purpose of c.f.b.c.boiler
ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine
what is the voltage between earth to neutral in lift.
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what parameters should we check to reduce the power bill
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
Testing procedure of DG alternator stability test
hello if any one have papers vof hpcl or sail, plz send me
What is servo motor? what is its purpose?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
why cable i burning without tripping. how can protect led street lights
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
