My switchgear busbar is rated at 2000A and just imagine the actual load on busbar is 1000A. From that busbar there are 10 outgoing feeders. Now the question is will the load be 1000A on each outgoing feeder or 100A per outgoing feeder. 2nd thing how do i calculate the load on individual feeder. Thanks for your time. Please provide some clarification on this issue.
- 1 Answers
- 4596 Views
- Alstom, I also Faced
- E-Mail Answers
Answer Posted / rajesh verma
Dear
2000a is the total capacity of your bus bar.from that
busbar there will be onather taping according to your
switchgear rating like if you have 10 outing and three in
among of them is capacity of 250 Amps and rest of 100 amps
then your three feedar will conect with 250a acapacity
busbar & can take max 250 AMP and the rest will connect
with 100 A Bus Bar so it can take 100 Amps max very simple
it all depends on your switch gear rating
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
Difference between megger test equipment and contact resistance meter test instruments?
how can maintain the power factor and why and this is how do work tell us
33kv Rated output avilable in market (any where in india)
what does a string of resistors in a series will do?
how to decide no of electrodes for 1600A LT Main incomer panel
please send me latest & previous years question papers for IOCL Technical level questions
how can i improve the power factor in domestic (230v)
what is the formula for hv test for cable and circuit breaker..????
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
How can calculate the rating of a servo stabilizer for given a specific load
how we sesign the transformer give some specifion regarding design of transformers
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
what is the meaning of WYE and DELTA in Electric meter?
