what is stearing oil grade SAE nos of gear box,in
passenger car
Answer Posted / sony andrews
SAE20W60 is the oil that is used nowadays in fourwheeler passenger cars in stearing box and gear box
Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
State some of kingpin offset application.
Single reduction is used in final drive when it is about a) 6:1 b) 8:1 c) 10:1 d) 12:1
What is the basic difference between honing and boring.
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
How does the thermostat work?
Why different types of sound are produced in different bikes though they are run on Si engine
If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above
Discuss the Otto cycle.
How can you test the speedo meter?
The main function of transmission is a) To provide means to vary the torque ratio between the engine and the road wheels b) To provide neutral position c) To provide means to back the car d) all of the above
Explain the concept of cc of engines?
The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above
What are three methods of heat transfer?
What is Maru A Process?
What is the diffrence bitween bs2 & bs3 engine?