Interested to Buy Any Domain ? << Click Here >> for more details...
hello, I need to know exactly what happen in the motor
while it is connected to the (star/delta) starter,
mechanical and electrical. Thaks for answering
- 3 Answers
- 5772 Views
- I also Faced
- E-Mail Answers
Answer Posted / mujeeeb
ACCORDING TO MOMENT OF INERTIA ,THE MOTOR WHICH WAS AT
REST TAKES MORE CURRENT TO START IT TAKES ABOUT SIX TO
SEVEN TIMES THE NOARMAL SO IT DRAWS MORE CURRENT ON ACCOUNT
IT TAKES MORE AMOUNT OF REACTIVE POWER SO THERE WILL BE
MORE BURDEN ON LINE SUPPLYING THE VOLTAGE TO THE MOTOR.SO
WE GO FOR THE STATERS TO REDUCE THE STARTING CURRENT TAKEN
BY MOTOR,IN STAR DELTA STARTER THE STARTING CURRNT IS 1/3
TIMES OF THE CURRENT TAKEN IN DELTA CONNECTION AT
STARTING ,SO WE START THE MOTOR IN STAR AND AFTER SOME TIME
IT WILL AGAIN RUN IN THE DELTA.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
Zone of protection and tripping scheme of arc protection relay.
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
please explain how to do 'pole drop test' on generator?
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
The loads are connected with phase and ground then why current flow as the loads ?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
what is the correct format to create a resume for interview??
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
What is the main cause of magnetism?
