Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between stress and pressure?. what
is the difference between moment and torque?
- 69 Answers
- 109380 Views
- College School Exams Tests, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / pradeep berry
Pressure is in balloons, pressure is in cylinders, pressure
is active when enclosed,
while Force is push, pull, moving a thing etc.
this is what is naturally happening and will indicate the
difference.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hi this is swaroop i appliled for masters in us for mba and my ielts score is 5.5 and no gre and i have 14 backlogs
purpose of primary and secondary air? causes of smoke?
What is the difference between gear motor and a stepper motor? Like i want to use gear motor for its excessive torque to move my robot. Can i use stepper motor instead?
How to find the max load of the engine?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
What is a uniformly distributed load?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What are the causes of low compression in the main engine?
Did you have a favorite project that you had to do while in school?
Can some one please show me the design of a POT Bearing.
pls send me HPCL model question paper for the post of officer trainee for mechanical engg. tnk u....
What are the items to inspect after cylinder liner is pulled out
What is the effect of addition of zinc in copper? What is the use of 70/30 brass ?
i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.
What are the causes if one cylinder in a diesel engine has a high temperature?
