Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ferozh
they are made by piercing the steel tube and rolling simultaneously, in order to get the hollow tube. they are also produced by cold extrusion techniques.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
If one lamp connects between two phases it will glow or not?
Define closed loop control system.
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Why are lt windings placed near the core?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
What are books to be referred for KPTCL exam?
Single line diagram for dbb (double bus bar)system.
What is the cut-off rate?
What is an iron loss or core loss pi?
Explain what is rated speed?
what is rocking arrangement in arc heating
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
state the working of discharge lamp?
operation of protection relay watchdog contact?
Why is tan-delta test and capacitor measurement done on alternator?
