Interested to Buy Any Domain ? << Click Here >> for more details...
What do you mean by 4.44 in this transformer equetion
E=4.44 nfqm
- 4 Answers
- 14431 Views
- Bharat Bijlee, I also Faced
- E-Mail Answers
Answer Posted / shaikh_mohammedfarhan
U Can't change in eqition
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
I am B.E.electrical engineer having 7 years of experience in Transformer testing upto 315 MVA.I want to khow how I can get the 'Electrical Valuer' License.
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
why high speed tripping relay is used in protection circuit why not normal relay
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is ramping rate of generator
What is the ratio of true power to apparent power in an ac circuit?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
design a 3 bit synchronous and asynchronous counter using T- flipflop
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
What is deference between MCB & MCCB & ISOLATOR
hi frnz,can somebody give me any project work? i am a 2nd year student & interested in practical works...plz give me some projects
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
